- #SAMPLETANK 3 CPU USAGE DRIVERS#
- #SAMPLETANK 3 CPU USAGE ANDROID#
- #SAMPLETANK 3 CPU USAGE SOFTWARE#
- #SAMPLETANK 3 CPU USAGE CODE#
#SAMPLETANK 3 CPU USAGE SOFTWARE#
#SAMPLETANK 3 CPU USAGE ANDROID#
#SAMPLETANK 3 CPU USAGE DRIVERS#
Recently Released Critical Drivers - Read Only.Recently Released Service Tips - Read Only.
#SAMPLETANK 3 CPU USAGE CODE#
PPS: well now I'm not sure if it is a chip level (like EEPROM value so chip just read it) or firmware level (like UEFI settings, and some UEFI code to be executed to access those settings), but anyway it slightly offtopic for the thread about WMI errors, lol :) However, you can control it by setting thresholds using TLP. You cannot change the basic behavior described above, because it is hard-coded into the EC firmware by the vendor. This makes the process work even when the laptop is switched off or no operating system is running:Ĭharging starts when connecting the charger, but only if the battery charge level is below the start charge threshold ( START_CHARGE_THRESH_BATx) it will not charge when the level is above the start charge thresholdĬharging stops when reaching the stop charge threshold ( STOP_CHARGE_TRESH_BATx) PS: proof that threshold is chip level setting (TLP cite):īattery charging is a process controlled by the embedded controller (EC) of your laptop. I want something similar to exists for Windows. So that it is independent from UEFI and so that even when the laptop is off and UEFI is not running the controller is still able to do the job and charge up to threshold.īTW, here is the Linux project for buttery stuff TLP, which allow to set the threshold. Most probably the battery charge controller is responsible for that. I assume that the threshold is actually set on a chip level. Kontakt with its Instruments Banks is better choice, but also for that you must have big RAM for many high quality sounds.Fully agree! UEFI setting is a good idea. Also in high power systems must be played in "hybrid" modus like Lylo wrote, but you have more headroom, cause you can play DFD more big instruments, not all !!! The best compromisse is to load Drum Kits and maybe Bass sounds in memory and other acc. I wrote that all can minimized noices, but not eliminate it at all when your Style need very big indepedance Instruments. Than it is big difference between 1.000MB/sec and about 4.000MB/sec storrage speed. It is not only PassMark points difference, it is also 15MB cache vs 8MB cache, than DDR4 vs DDR3, also 28 vs 16 PCIe-Lines, 6-Cores vs 4-Cores and very important Memory Band 76,8GB/sec vs only 21GB/sec. It is so that i7-6800K is like two i7-2600K in one CPU. i7-6800K it has PassMark over 13.600 points and i7-2600K has only 8.480 PassMark points.
I wrote about high power systems from newest generation, f.e. Intel i7-2600k with 16GB RAM and 2 SSD in RAID 0 protokol is one good middle power system, but not enough good for playing and changing Styles in vA² without play stop with Indepedence as only one Sound Engine for vArranger². With "Read from RAM" in Indepedence you have no problems with noices and cracles by "on flay" Style change, but for big instruments from Indepedence Content, you must have much RAM (32GB and more) when you will to load the best Indepedance sounds in a same time. This what Lylo wrote is the only alternative for middle power systems.
0 kommentar(er)
